Falcon DD-7098 Original Fridge Filter (497818), Banseok Puritec Ltd.
Replaces Falcon External - (497818) DD-7098
Availability:
In stock
Postage:
Delivery:
13,99 € (18,74 €)
Colissimo online tracking with signature on delivery
-
Description
-
Alternate
-
Quality
-
Specification
-
Fridges
-
Installation
-
Reviews
The DD-7098 (497818) water filter cartridge for Falcon fridges:
- is an original external refrigerator water filter
- is a replacement cartridge for side-by-side refrigerators that use externally fitting cartridges
- is designed to be installed on the 1/4" diameter cold water supply line to the refrigerator/icemaker
- connector type water filter Quick push-in connecters (John Guest connectors)
- uses 1/4" (6.35 mm) quick-connecting (push in) fittings
- includes 2x Mounting brackets and 2x Tie wires
- is tested and Certified by NSF International against NSF/ANSI Standards 42
- Daewoo, Bosch, Hotpoint-Ariston, Neff & Siemens recommend replacement every 6 months
- is manufactured by Banseok Puritec Co. Ltd. (country of origin Korea)
- EAN 4260234882391
The DD-7098 fridge filter for Falcon fridges replaces or is compatible with the following filter part numbers:
- K32010CB
- DA2010CB
The DD-7098 Banseok Puritec Ltd. water filter reduces the following health related contaminants:
- Chlorine Taste and Odour
Tested and Certified by NSF International against NSF/ANSI Standards 42 for the reduction of Chlorine Taste and Odour.
Note: The filter produces cleaner, better tasting and healthy drinking water & ice.
Important: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
The DD-7098 (497818) water filter operating specifications are as follows:
- Flow Rate
- Operating Temperature
- Operating Pressure
- Technology
- Capacity
- Service Life
- Dimensions
1.3 lpm
min 0.6°C / max 38°C
min 138 kPa (20 psi) / max 827 kPa (120 psi)
Carbon Block
2 000 litres
6 months
approximately 5 cm x 30 cm
Important: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Change filter at least every 6 months.
The DD-7098 (497818) refrigerator filter is compatible with the following Falcon fridges:
- SXS Black
- SXS Blue
- SXS Cranberry
- SXS Cream
- SXS Ivory
- SXS Red
- SXS SSteel
- SXS White
Important: Some manufacturers use the same fridge model number for fridges supplied with both internal and external filter systems, please make sure that your fridge uses an External water filter before ordering this item.
Installation and replacement procedure for the DD-7098 fridge water filter:
- Turn off the cold water supply.
- Remove the tubing from the ends of the old filter. Note: Take precautions as water will drain from the filter and pipes.
- Align the new water filter with the water flow direction.
- Connect the tubing to the appropriate end of the filter by firmly pushing the tubing all the way until tightly sealed.
- Turn on the water supply and switch on the ice maker.
- Run water through the dispenser for 3 minutes to purge the system.
- Check the filter area for leaks.
- Reset the "change filter" indicator light, if your fridge has one. Please refer to our FAQs on how to reset the "change filter" indicator light for a particular fridge manufacturer.
When to change a filter: There is a replacement indicator light for the water filter cartridge on the temperature control panel. The filter cartridge should be replaced when the replacement indicator light turns red, or every 6 months, or if the flow of water to a dispenser or icemaker decreases.
Important: It is essential that operation, maintenance and filter replacement be carried out in accordance with manufacture's recommended procedures and guidelines for this product to perform as advertised. Failure to do so may void warranty.