GE Monogram PF-03 Replacement Fridge Filter (MWF), PurityPro
Replaces GE Monogram MWF, MWFINT, SmartWater, WF287, WLF-GE01, Internal - (MWF) PF-03
Availability:
In stock
Postage:
Delivery:
14,99 € (18,96 €)
Colissimo online tracking with signature on delivery
-
Description
-
Alternate
-
Quality
-
Specification
-
Fridges
-
Installation
-
Reviews
The PF-03 (MWF) water filter cartridge for GE Monogram fridges:
- is a replacement internal fridge water filter, replaces GE MWF
- is a replacement cartridge for all GE side-by-side refrigerators with a round white plastic filter located in the top compartment of the refrigerator
- is tested according to NSF 42 Standards
- is manufactured by ACE+ (country of origin Korea)
- EAN 5060388572723
The PF-03 fridge filter for GE Monogram fridges replaces or is compatible with the following filter part numbers:
- MWF
- WLF-GE01
- MWFINT
- SmartWater
- WF287
- MWF v1
The PF-03 PurityPro water filter reduces the following health related contaminants:
- Chlorine Taste and Odour
The filter is teseted according to NSF 42 Standards.
Note: The filter produces cleaner, better tasting and healthy drinking water & ice.
The PF-03 (MWF) water filter operating specifications are as follows:
- Flow Rate
- Operating Temperature
- Operating Pressure
- Function
- Technology
- Capacity
- Service Life
- Dimensions
1.9 lpm
min 0.6°C / max 37.8°C
min 220 kPa (30 psi) / max 827 kPa (120 psi)
Chemical and Mechanical Reduction
Coconut Carbon Block
1 514 litres
3 months
approximately 8.5 cm x 13.5 cm
Important: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Change filter at least every 3 months.
The PF-03 (MWF) refrigerator filter is compatible with the following GE Monogram fridges:
- ZCE23NGTESS
- ZHE25NGTESS
- ZHE25NGWESS
- ZSEB420DY
- ZSEB480DY
- ZSEB480NY
- ZSEP420DYSS
- ZSEP480DYSS
Important: Some manufacturers use the same fridge model number for fridges supplied with both internal and external filter systems, please make sure that your fridge uses an Internal water filter before ordering this item.
Installation and replacement procedure for the PF-03 fridge water filter:
- Slowly turn the old cartridge 1/4 turn to the left (counter clockwise). Note: Do not pull down on the cartridge.
- Remove and discard the old filter (the water will shut off automatically).
- Peel off the protective cover from the new cartridge.
- Fill the new replacement cartridge with cold water to allow for better flow immediately after installation (you can use tap water).
- Line up the arrow on the cartridge with the cartridge holder. Note: Do not force it up into the holder.
- Turn the filter 90 degrees right (clockwise) until the cartridge stops. Do not over tighten.
- Run water through the dispenser for 3 minutes to purge the system.
- Check the filter area for leaks.
- Reset the filter status light by pressing and holding the Reset Water Filter button for 3 seconds.
When to change a filter: There is a replacement indicator light for the water filter cartridge on the temperature control panel. The filter cartridge should be replaced when the replacement indicator light turns red, or every 3 months, or if the flow of water to a dispenser or icemaker decreases.
Important: It is essential that operation, maintenance and filter replacement be carried out in accordance with manufacture's recommended procedures and guidelines for this product to perform as advertised. Failure to do so may void warranty.